Materials: RAST bedside table, EKBY JARPEN shelf, BORRIS door mats x 2
It was finally time (after procrastinating for years), to put together ramp for Chiro our Dachshund.
First we attached hinges to the (unbuilt) side of the RAST table, doing this allows you to build the table first.
Hinges screwed in, it was time to build the RAST table. Very simple and straightforward build, just line everything up and pop in all the screws.
Side table built, we flipped it upside down to measure and mark out where to attach the hinges on the EKBY shelf. With the areas to attach screws marked, we used a power drill to make small indentations so the screws will line up better.
Once all the screws are attached, just flip everything the right side up. It’s almost done!
Cut up the BORRIS door mats to make 3 separate small placemats with nice rounded edges, just use the sides of the door mat as a template and mark out where cutting is needed.
Once that is done, use contact glue and carefully place the already-cut door mats onto the shelf. Leave it for a few hours for the glue to dry and all done! We also affixed some floor protection studs on the base of the ramp and table.
via IKEA Hackers http://ift.tt/1hH7sqD From Louis
No comments:
Post a Comment